INSTALLATION
LOUDSPEAKER CONNECTIONS
©
Check that your mains supply voltage
agrees with the voltage setting indicated
on the rear panel of the unit.
If your mains supply voltage is different,
consult your Arcam dealer.
MAINS SAFETY
This product is normally supplied with a
moulded mains plug already fitted to the
lead. If for any reason the plug needs to
be removed, it must be disposed of
immediately and securely, as it is a
potential shock hazard when inserted into
a mains socket.
If the plug is removed then the remaining
lead must be rewired as follows:
The blue wire must be connected to the
terminal which is coloured blue or
marked with the letter N.
The brown wire must be connected to
the temiinal which is coloured brown or
marked with the letter L.
The green and yellow wire must be
connected to the terminal which is
coloured green and yellow, or marked
with the letter E or the safety earth
symbol.
When replacing the fuse in the supplied
moulded mains plug, the integral fuse
holder/cover must always be refitted.
Warning: This apparatus must be
earthed.
MAINS SUPPLY CONNECTIONS
Insert the lEC line socket of the mains
lead fully into the power inlet on the rear
panel. Connect the other end to your
mains supply.
Insert the red plugs into the red sockets
and the other plugs into the black
sockets. If your speaker cable has bare
ends, the positive conductor can usually
be identified by a ridge or coloured
marking.
Ensure that no stray strands are allowed
to touch another cable or the amplifier's
casing. This can cause a short circuit and
damage your amplifier!
@,©
Connect terminals ®
speaker and terminals
speaker.
to your right
© to your left
To drive a second pair of speakers,
connect terminals ® to the right speaker
and terminals ® to the left speaker.
Both pairs of speakers may be driven
simultaneously provided each pair is rated
between 8 and 16 ohms.
CONNECTING YOUR SOURCE
COMPONENTS
For the following connections, insert the
red phono plugs into the sockets labelled
'R' and the other phono plugs into the
sockets labelled 'L'.
®
PWR AMP IN - To use your Delta 290
as a power amplifier, connect the output
of your pre-amplifier to PWR AMP IN.
Set the internal selector switch to EXT
INPUT position.
PREAMP OUT - To use your Delta
290 as a pre-amplifier, connect
PREAMP OUT to your power
amplifier's input.
Please note: the PREAMP OUT
sockets are permanently active.
(8 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels