Arcam DV78 Spécifications télécharger pdf (Page 6)

100

DV78

English

DV78

Connecting to a power supply

Mains lead

The appliance is normally supplied with a moulded mains plug

already tted to the lead. If for any reason the plug needs to

be removed, it must be disposed of immediately and securely,

as it is a potential shock hazard when inserted into the mains

socket. Should you require a new mains lead, contact your

Arcam dealer.

Wrong plug?

Check that the plug supplied with the unit ts your supply and

that your mains supply voltage agrees with the voltage setting

(115V or 230V) indicated on the rear panel of the unit.

If your mains supply voltage or mains plug is different, consult

your Arcam dealer.

Plugging in

Push the plug (IEC line socket) of the power cable supplied with

the unit into the socket (POWER INLET) in the back of the unit.

Make sure it is pushed in rmly.

Put the plug on the other end of the cable into your power

supply socket and switch the socket on.

Progressive video

If your television is capable of accepting a progressively

scanned video signal, you may wish to use the progressive

video output from the DV78.

To connect the progressive output of the DV78 to your TV,

follow the instructions above for connecting component video. If

you are unsure whether your TV can accept progressive video,

please refer to its instruction manual or consult your dealer.

Connecting Digital audio

If you have an external surround sound decoder, receiver or

D-A converter that you wish to use with the DVD player, then

you will need to connect it using either a coaxial or optical lead.

These digital outputs provide PCM, Dolby Digital, DTS or MPEG

multi-channel audio, depending on the source material. It is also

possible to set the digital output always to output 2-channel

PCM (stereo mix-down) via the setup menu.

If possible, use the coaxial connection as this may offer slightly

better performance. Connect the coax output of the DVD player

to the digital audio coax input of the decoder/D-A converter

or receiver using a phono cable designed for digital audio

interconnection.

Alternatively, connect the optical output of the DVD player to the

optical input of the decoder/D-A converter or receiver using a

TOSLINK optical lead.

Connecting Analogue audio

If you wish to use the high quality D-A converters of the DVD

player, then you will need to use the analogue audio outputs of

the DVD player.

One output pair is provided, labelled ‘L’ (left) and ‘R’ (right).

Connect these outputs to the input of your amplier using a

suitable pair of interconnect cables.

Remote Control input

The REMOTE IN input can be used to pass RC5 codes to the

DV78 if it is installed in a position (or system) where infrared

cannot be used.

Downloaded From Disc-Player.com Arcam Manuals

1 2 3 4 5 6 7 8 9 10 11 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Arcam DV78 Spécifications Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de DVD Arcam DV78