Arcam DV27 Spécifications télécharger pdf (Page 12)

English

Using the remote control

ANGLE

CD DVD

SETUP STATUS SRCH

ZOOM AUDIO MEM RTN

MODE

SUBT TITLE MENU

RPT CLEAR

PROG

A-B

DISP

5 6

DVD

MUTE

OPEN

CD/DVD REMOTE

CR-314

NOTE: Remember to install the two AAA batteries

supplied before trying to use your remote control.

Do not place anything in front of the FMJ badge on the

front panel (where the IR receiver is located), or the

remote control may not work.

Volume +/–

Adjusts the volume on Arcam remote-controllable amplifiers.

Note that the volume (+/–) controls and MUTE button have no

effect on the audio output level of the DVD players.

MUTE

Stops sound to the speaker outputs of certain Arcam amplifiers.

OPEN

Opens and closes the disc tray.

Playback control

PAUSE ( ), PLAY ( ) and STOP ( ) (see page 11).

Advanced controls

These buttons are described on the facing page.

0–9 keypad

This allows direct access to individual tracks on audio CDs. To

select a track, press the corresponding keypad button followed

by OK. For tracks greater than 9, enter the digits in sequence. For

example, to play track 15, press 1, then 5, then OK.

CD/DVD

Ensure that DVD mode is selected using the CD/DVD toggle

button. The ‘DVD’ LED above the CD/DVD button is lit briefly

when DVD mode is selected.

DISP (display)

Dims or turns the DV27’s display on or off. Turning the display off

generally gives a slight improvement in sound quality.

Pressing DISP once turns the display off; twice dims the display. To

restore the display to full brightness, press DISP a third time.

A–B

This button enables you to repeat a selected

section from the disc (see page 14).

RPT (repeat)

Press RPT to cycle through the repeat play options.

Fast play and Skip chapter/tracks

Play fast ( ) and Skip ( ) chapters/tracks in both

directions (see page 11).

Standby

Press STANDBY to toggle the standby state of the DVD player.

Note that Arcam CD players are not controlled by this button.

CLEAR

Use CLEAR within the ‘Program’ and ‘Bookmark’ menus to clear

a numeric field (see pages 14–15).

PROG (program)

You can program a selection of up to 20 chapters/tracks from a

disc to play in any order. Press PROG to access the ’Programme’

menu (see pages 15 and 17).

Slow play

Press or on the remote control to play slow forward or

backwards. There are four speeds of slow playback: 1/5, 1/4,

1/3 and 1/2. Press the button repeatedly to cycle through the

different speeds. To resume normal playback speed, press PLAY.

Note that slow play does not apply to audio CDs.

Cursor pad and OK button

Use the cursor pad to navigate the On Screen Display (OSD)

and menu pages. Confirm your selection with the OK button.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Commentaires sur ces manuels

Pas de commentaire

Arcam DV27 Spécifications Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de DVD Arcam DV27