Arcam DV135 Instructions d'exploitation télécharger pdf (Page 6)

DV135

E-6

The remote-control and trigger inputs

The REMOTE IN input can be used to pass RC5 codes to the DV135 if it is installed in a position (or

system) where infrared cannot be used. If this is required, please contact your dealer for further

information.

The

TRIGGER IN input can be used to switch the DV135 in and out of stand-by. Connecting the

trigger output of your Arcam amplier (or other compatible device), will cause the DV135 to come

out of stand-by automatically when the amplier is switched on, returning to stand-by when the

amplier is switched off. Please see your amplier handbook for further information.

In normal use there is no need to make any connections to these inputs.

Inserting the batteries into the remote control

The remote control requires two ‘AAA’ batteries to operate. To insert the batteries into

the remote control, please follow the instructions in the side panel diagram:

Notes on inserting the remote control batteries

Incorrect use of batteries can result in hazards such as leakage and bursting.

Do not mix old and new batteries together.

Do not use different kinds of battery together—although they may look similar,

different batteries may have different voltages.

Ensure that the plus (+) and minus (—) ends of each battery match the

directions in the diagram on the right.

Remove batteries from equipment that is not going to be used for a month or

more.

When disposing of used batteries, please comply with government (or other)

regulations that apply in your country or area.

Using the remote control

Please keep in mind the following when using the remote control:

Ensure that there are no obstacles between the remote control and the remote

sensor on the DV135. The remote has a range of about 7 metres. (If the remote

sensor is obscured, the remote control input jack on the rear panel is available.

Please contact your dealer for further information.)

Remote operation may become unreliable if strong sunlight or uorescent light is

shining on the remote sensor of the DV135.

Replace the batteries when you notice a reduction in the operating range of the

remote control.

Connecting to a power supply

Mains lead

The appliance is normally supplied with a moulded mains plug already tted to the lead. Check that

the plug supplied with the unit ts your supply and that your mains supply voltage agrees with the

voltage setting (

115V or 230V) indicated on the rear panel of the unit. If for any reason the plug needs

to be removed, it must be disposed of immediately and securely, as it is a potential shock hazard when

inserted into the mains socket.

If your mains supply voltage or mains plug is different, or you require a new lead, please consult your

Arcam dealer.

Plugging in

Push the plug (IEC line socket) of the power cable supplied with the unit into the socket (POWER INLET)

in the back of the unit. Make sure it is pushed in rmly.

Put the plug on the other end of the cable into your power supply socket and switch the socket on.

The remote control

input requires a mono

3.5mm jack, with the

tip active and the sleeve

grounded.

The remote control signals

must be in modulated RC5

format (at 36kHz), with a

voltage level of between

5V and 12V.

1. Open the battery

compartment by pressing

the button on the back of

the handset.

2. Insert two AAA batteries into

the battery compartment, as

in the diagram.

3. Lower the end cap onto

the plastic locating plate in

the handset. This acts as

a hinge, and you can now

push the end cap rmly into

its locked position with a

click.

1 2 3 4 5 6 7 8 9 10 11 ... 91 92

Commentaires sur ces manuels

Pas de commentaire

Arcam DV135 Instructions d'exploitation Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de DVD Arcam DV135